Printable Temporary Tattoo Paper A4, 1 set
Instructions Temporary Tattoo Paper You need a pair of scissors or cutting machine, cloth, water and the two different sheets you received: a clear decal tattoo paper sheet (with small red dot on back side) and an adhesive sticker sheet.
- Arrange the designs with any graphic software program on a page, be sure to adjust your page settings to A4. Don't forget to mirror the images if necessary (always mirror names, texts, numbers, banners and any other design that is not symmetric).
- It is recommended that you print your design on a plain paper first before using the waterslide removable tattoo paper. PLEASE NOTE: The water slide temporary tattoo paper should be fed into your printer one sheet at the time. You should also remove all other paper from your printer. This is to avoid a paper jam in the printer because the tattoo paper is thicker than regular print paper.
- Print on the glossy side of the decal tattoo paper. (Red dot denotes backside of sheet, don’t print on this side).
- Wait until the ink is fully dry (2 - 3 minutes).
- Remove the front side of the adhesive sticker sheet.
- Apply the adhesive sticker sheet to the printed side of the tattoo sheet. Be sure to remove all air bubbles.
- Use scissors or cutting machine to cut around each individual tattoo design, as close as possible to the design.
- Remove the adhesive backing from the tattoo paper.
- Apply the tattoo on your skin/tumbler/resin project etc and press firmly for 20 seconds. The area must be clean and dry.
- Wet the tattoo with a damp cloth for 60 seconds. Make sure the tattoo is thoroughly wet.
- Remove the paper to reveal the tattoo.
- Blot dry.
